A novel directional coupler loaded with feedback capacitances on the coupled lines is presented. Its effect of enhancing the coupling is qualitatively shown by deriving an equation for the coupling. Besides, a method to compensate for the phase difference between the even and odd modes of the coupler is presented. To demonstrate, a novel tandem 3-dB coupler consisting of the proposed coupled lines is designed and described. In addition, a waveguide (rectangular coaxial line) 8×8 HYB matrix using planar double-layer structure that is composed of the proposed tandem 3-dB couplers and branch-line couplers, which is operated in S-band, is designed and fabricated showing excellent performance.

In this paper, a measurement method for the impedance and mutual coupling of multi-antennas that we have proposed is summarized. Impedance and mutual coupling characteristics are obtained after reducing the influence of the coaxial cables by synthesizing the measured S-parameters under the condition that unbalanced currents on the outside of the coaxial cables are canceled at feed points. We apply the proposed method to two closely positioned monopole antennas mounted on a small ground plane and demonstrate the validity and effectiveness of the proposed method by simulation and experiment. The proposed method is significantly better in terms of the accuracy of the mutual coupling data. In the presented case, the errors at the resonant frequency of the antennas are only 0.5dB in amplitude and 1.8° in phase.

We propose a simple and small phase shifter for a beam-steerable base-station antenna. This phase shifter has no metallic heterojunction, and the phase shift is controlled by moving an M-shaped dielectric plate between the strip conductor and the ground plane of a strip line. We derive a design equation from the condition that at the center frequency f0, the reflection coefficient = 0. In this phase shifter, the reflection coefficient becomes minimum at f0 regardless of the movement distance, r, of the dielectric plate, and the relationship between the phase shift and r is linear. These characteristics are verified by performing simulations and measurements. The size of the M-shaped dielectric phase shifter is 0.27λ00.12λ0, where λ0 is the free-space wavelength at f0. The insertion loss is smaller than about 0.2 dB within a fractional bandwidth of 10%, and the phase shift can vary from 0 to about 80 degrees.

In this paper we propose a new far-field RCS prediction method using cylindrical or planar near-field RCS data. First we derive the relation between RCS and the scattering coefficient using physical optics technique. The far-field RCS prediction algorithm is obtained by approximating the relation using the condition of Fresnel region and the paraxial constraint of scanning angle in the case of cylindrical or planar scanning. Finally we predict the far-field RCS using measured or calculated near-field RCS data of the conducting rectangular prism or plate. The validity of the proposed algorithm is demonstrated.

In this paper, an analysis method for calculating balanced and unbalanced modes of a small antenna is summarized. Modal condactances which relate dissipated power of the antenna are directly obtained from standard S-parameters that we can measure by a 2-port network analyzer. We demonstrate the validity and effectiveness of the proposed method by simulation and measurement for a dipole antenna with unbalaned feed. The ratio of unbalanced-mode power to the total power (unbalanced-mode power ratio) calculated by the proposed method agrees precisely with that yielded by the conventional method using measured radiation patterns. Furthermore, we analyze a small loop antenna with unbalanced feed by the proposed method and show that the self-balancing characteristic appears when the loop is set in resonant state by loading capacitances or the whole length of the loop is less than 1/20th the wavelength.

A method is proposed for improving the accuracy of the characteristic basis function method (CBFM) using the multilevel approach. With this technique, CBFs taking into account multiple scattering calculated for each block (IP-CBFs; improved primary CBFs) are applied to CBFM using a multilevel approach. By using IP-CBFs, the interaction between blocks is taken into account, and thus it is possible to reduce the number of CBFs while maintaining accuracy, even if the multilevel approach is used. The radar cross section (RCS) of a cube, a cavity, and a dielectric sphere were analyzed using the proposed CBFs, and as a result it was found that accuracy is improved over the conventional method, despite no major change in the number of CBFs.